Product Details:
Payment & Shipping Terms:
|
| Other Name: | 12VDC Piezo Buzzer | Rated Voltage: | 12V |
|---|---|---|---|
| Operating Voltage: | 3-24V | Rated Current: | ≤12mA |
| Sound Output: | ≥95dB | Resonant Frequency: | 2700±500Hz |
| Operation Temperature: | -20~+80℃ | Weight: | 11g |
| Highlight: | piezo electronic buzzer,alarm piezo buzzer |
||
Continuous tone wire type piezo buzzer Φ42*16mm with oscillator circuit
Description:
A piezo buzzer generates sound because of the piezoelectric effect from the piezoelectric ceramic which drives the metallic diaphragm to vibrate.
There are two main types of buzzer: active and passive.
A passive buzzer emits a tone when a voltage is applied across it. It also requires a specific signal to generate a variety of tones. The active buzzers are a lot simpler to use, so these are covered here.
An active buzzer can be connected just like an LED, but as they are a little more robust, you won’t be needing a resistor to protect them.
Feature:
• They feature extremely low power consumption in comparison to electromagnetic units.
• Because these buzzers are designed for external excitation, the same part can serve as both a musical tone oscillator and a buzzer.
• They can be used with automated inserters.Moisture-resistant models are also available.
• The lead wire type with both-sided adhesive tape installed easily is prepared.
Application:
Electric ranges, washing machines, computer terminals, various devices that require speech synthesis output.
Specifications:
| Type | Unit | 4216YX |
| Rated voltage | V | 12 |
| Operating voltage | V | 3-24 |
| Rated current | mA | ≤12 |
| Sound output at 30cm | dB | ≥95 |
| Resonant frequency | Hz | 2700±500 |
| Operating temperature | ℃ | -20~+80 |
| Weight | g | 11 |
Precautions for use:
• Do not apply DC bias to the piezoelectric buzzer; otherwise insulation resistance may become low and affect the performance.
• Do not supply any voltage higher than applicable to the piezo- electric buzzer.
• Do not use the piezoelectric buzzer outdoors. It is designed for indoor use. If the piezoelectric buzzer has to be used outdoors, provide it with waterproofing measures; it will not operate normally if subjected to moisture.
• A piezoelectric ceramic material of approximately 100μm thick is used in the sound generator of the buzzer. Do not press the sound generator through the sound release hole otherwise the ceramic material may break. Do not stack the piezoelectric buzzers without packing.
• Do not place any shielding material or the like just in front of the sound release hole of the buzzer; otherwise the sound pressure may vary and result in unstable buzzer operation. Make sure that the buzzer is not affected by a standing wave or the like.
• Be sure to solder the buzzer terminal at 350℃ max.(80W max.)(soldering iron trip) within 5 seconds using a solder containing silver.
• Avoid using the piezoelectric buzzer for a long time where any corrosive gas (H2S, etc.) exists; otherwise the parts or sound generator may corroded and result in improper operation.
Dimension: (mm)
Tolerance: ±0.5
Continuous tone
Frequency response:
Contact Person: Mr. Roy Zhang
Tel: 86 574 55878090
Fax: 86-574-55878097
