Payment & Shipping Terms:
|Other Name:||Terminal Block Socket||Screws:||M3.0 Steel, Zinc Plated|
|Housing:||PA66, UL94V-0||Clamp:||Brass, Ni Plated|
|Contact:||Phosphor Bronze, Ni Plated||Cover:||PA66, UL94V-0|
|Soldering Temperature:||250℃ ±5℃ / 5S||Operating Temperature:||-40℃～+105℃|
screw terminal connector,
printed circuit board connector
Female pluggable terminal block connector 2 ~ 24 poles , 5.08mm pitch
Terminal blocks, for wire to board connection. Terminal block in two parts that can be separated, one part for cable connection, and one part for PCB mounting.This solution enables to easily connect and disconnect.
Why you need a terminal block?
• Screw terminals are low in cost when compared to other types of connectors
• It can be readily designed into products for circuits carrying currents of from a fraction of an ampere up to several hundred amperes at low to moderate frequencies.
• The terminals easily can be re-used in the field, allowing for the replacement of wires or equipment, generally with standard hand tools.
• Screw terminals usually avoid the requirement for a specialized mating connector to be applied to the ends of wires.
The terminal blocks are used in almost all electric appliances that need 240-volt power supply. Electric dishwashers, dryers and ranges use heating elements to produce heat. Heating elements need 240-volt electricity supply. The terminal block is normally located inside the appliance at the front or at the back. All the internal wires and the power cord connect to the terminal block. The terminal block is at the end of the power cord that supplies power to the appliance. It has connectors for attaching electric wires to them.
|Rated voltage||300V / 320V|
|Rated current||15A / 20A|
|Dim P||Dim L|
If you think that the terminal block is causing any problem in your appliance, you can follow the steps below to test:
1. Take precaution: Turn off the power source by putting the control panel switch at OFF position. Unplug the power cord of your appliance from the wall outlet (if there is any).
2. Find terminal block: Remove the cover of the appliance where the power cord enters the appliance. Follow the power cord, you will find the terminal box at the end.
3. Test terminal block visually: Check carefully if there are any cracks or corroded wires. Also check for burned or loose wires. If you see any of these problems, replace the terminal block.
4. Disconnect terminal block: With the power source turned off, remove the mounting screws for the terminal block. Label the wires with masking tapes indicating the terminals they connect to. Pull off the wire connectors after unscrewing them. Disconnect the ground wire from the block. Disconnect the terminal block by pulling.