Payment & Shipping Terms:
|Other Name:||Spain Potentiometer||Total Resistance Tolerance:||1kΩ≤Rn≤1MΩ ±20% ; 1MΩ≤Rn≤5MΩ ±30%|
|Residual Resistance:||≤5‰ Rn(3Ω Min)||Electrical Rotation Angle:||220°±20°|
|Max Operating Voltage:||50VDC||Resistance Taper:||Line B|
|Rated Power:||0.15W(50°C)||Rotation Of Noise:||≤100mv|
rotary switch potentiometer,
variable resistor potentiometer
10mm spain trimpot PT10, used in circuits for tuning and recalibration
A trimpot or trimmer potentiometer is a small potentiometer. When they are used as a variable resistance (wired as a rheostat) they are called preset resistors. Trimpots or presets are normally mounted on printed circuit boards and adjusted by using a screwdriver. The material they use as a resistive track is varying, but the most common is either carbon composition or cermet. Trimpots are designed for occasional adjustment and can often achieve a high resolution when using multi-turn setting screws.
Several different versions of trimpots are available, using different mounting methods (through hole, smd) and adjusting orientations (top, side) as well as single and multi-turn variations.
• Single turn
Single turn trimmers/presets are very common and used where a resolution of one turn is sufficient. They are the most cost effective variable resistors available.
• Multi turn
For higher adjustment resolutions, multi-turn trimpots are used. The amount of turns varies between roughly 5-25, but 5, 12 or 25 turns are quite common. They are often constructed using a worm-gear (rotary track) or leadscrew (linear track) mechanism to achieve the high resolution. Because of their more complex construction and manufacturing, they are more costly than single turn preset resistors. The lead screw packages can have a higher power rating because of their increased surface area.
• Carbon resistive element
• Dustproof enclosure
• Polyester substrate
• Also upon request:
* Wiper positioned at 50% or fully clockwise
* Supplied in magazines for automatic insertion
* Long life model for low cost control potentiometer application
* Self extinguishable plastic UL 94V-0
* Cut track option
* Special tapers
* Mechanical detents
* Low & extra low torque versions
* Special switch option
Used for adjustment, tuning and calibration in circuits.
|Total rotation angle||235°±10°|
Rotation life: After 10,000 rotation, the changes impacted no more than ± (15% R +0.5 Ω ) rotational noise not more than 100 mv
Terminal strength: After welding (350 °C, 3,5 seconds) , the termination of terminal contacts should be good, no loosening of.
Soldering ability: Dip the terminals into tin tank at 260°C±5°C for 2±0.5 seconds, the soldering area should be more than 90%.
Resistance SR code table:
Contact Person: admin